USERMANUALModel 2135 Ethernet Micro-Bridge SALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007http://www.patton.comPart# 07M2135-UMDoc# 08303U2-
1718Notes_____________________________________________________________________________________________________________________________________________
1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 2135 components to be freefrom defects, and will—at our option—repair or replace the p
32.0 GENERAL INFORMATIONThank you for your purchase of this Patton Electronics product.This product has been thoroughly inspected and tested and is w
ated Cisco configuration will set serial interface (s0) to accommodatehalf bridging for the above example.Authentication is optional under PPP. In a
72135 10BaseT DTERJ-45 Pin No. RJ-45 Pin No.1 (TX+) 1 (TX+)2 (TX-) 2 (TX-)3 (RX+) 3 (RX+)6 (RX-) 6 (RX-)4.2 CONNECT TO THE DTE INTERFACE The DTE in
5.1.2 LED DescriptionsThe status LED blinks yellow from one to eleven times to indicatesystem status. Each pulse pattern is separated by a 2 second &
11APPENDIX APATTON ELECTRONICS MODEL 2135 SPECIFICATIONSLAN Connection: RJ-45, 10BaseT, 802.3 Ethernet sup-ported by Transparent LAN bridging D
13APPENDIX C10BaseT Interface Pin Assignment(RJ-45 Female Connector)(DTE Configuration)Pin # Signal1 TD + (data output from 2135)2 TD - (data outpu
15APPENDIX EPOWER SUPPLY INTERFACEVia 5VDC power jack (J1)Center Pin: +5VDC @ 500 mA minimunOuter Barrel: GroundAPPENDIX DTerminal Interface Pin Assi
Commentaires sur ces manuels